Super 1050 (2 and 3 place toolhead racks with locations to hold your complete conversion kits)

Note: Because the Super 1050 Toolheads can be set up with many different die configurations, please review the pictures to verify that this rack will work for your particular setup and needs.

Note:  The Super 1050 Toolhead rack will not work with Lighting Systems that are mounted to the underside of the Toolhead.

Dillon Super 1050 Toolhead Wall Mounted Storage Rack for up to 3 Toolheads and up to 3  Conversion Kits. Get your Dillon Super 1050 Toolheads, loaded with your expensive dies and powder throwers, out of your way!  This heavy duty steel toolhead rack holds your Dillon Precision Super 1050 toolheads and Conversion Kits safely and securely off of your reloading bench and onto the wall.  Just line up your rear alignment pin and the back ratchet bar and the toolhead slides smoothly into place.  The toolhead then rests nice and secure out of the way.  A slot for the shell plate sits behind the toolhead, so you always know where it is!  There are positions for the station one plunger, and the casefeed adapter, as well as a spot for your case gauges.

There is plenty of clearance so the toolheads are not damaged when removing and replacing them into the rack.  The rack is beautifully and professionally powder coated in a matte black finish. Stainless steel and aluminum hardware are used to tie the whole rack together.

Super 1050 Racks:
2 Place center to center on wall bracket holes 19.45” and back flange is at 8” and 16”– Overall width is about 21″.
3 Place center to center on wall bracket holes 28.20” and back flange is at 16” and 24”– Overall width is about 30″

Brackets are:
Three holes slotted vertically
Top hole to middle hole (centers) 1.60”
Middle Hole to Bottom Hole (Centers) 3.70”
Top hole to bottom hole spread (centers) 5.3”

Shipping –

2-Place $24.99 via FedEx Home Delivery or Ground (if shipping to a business)

3-Place $28.00 via FedEx Home Delivery or Ground (if shipping to a business)